Metal Bracelet Link Remover (Hammer)

Double-ended hammer
Material: Plastic and stainless steel.
One end of the hammer is made of plastic to prevent damage to the watch strap.

Plastic strap holder
Material: Plastic.
Use to secure the watch strap, allowing the pins to be removed.

Removal needles
Material: Stainless steel.
Used to pierce and insert the pins into the watch strap links.

Instructions for removing the pins from the links:

1. Secure the watch strap in the grey plastic holder.
2. Choose the most suitable needle, depending on the thickness of the pin securing the bracelet links. There are 3 sizes available.
3. Place the needle against the pin you wish to remove, and tap the base of the needle with the hammer to slowly remove the pin.
4. Do not strike too hard at first, so as not to damage the needle. Try tapping gently, and gradually increase the force depending on whether the pin is moving or not.
5. Continue tapping the needle until the pin is loose enough to be removed by pulling with two fingers, or with the help of a small pair of pliers.
6. Once you have removed the first pin, do the same for the rest.

Instructions for inserting the pins into the links:

1. To reinsert the pins into the links of the bracelet, overlap the links and insert the pin as far as possible until it clicks into place and is secure in the link’s hole.
2. Insert the strap into the plastic holder.
3. Use the plastic side of the hammer to fully seat the pin in the bracelet. Use the plastic part of the hammer to avoid damaging or scratching the watch strap if you miss the mark when tapping.